legend +25 oc +85 oc - - - - - - -55 oc power vdc +10 +10 ma 145 150 max. rf amplifier model TM6010PM available as: TM6010PM, 4 pin to-8 (t4) tn6010pm, 4 pin surface mount (sm3) fp6010pm, 4 pin flatpack (fp4) bx6010pm, connectorized housing (h1) features superior phase noise performance high output power: +23 dbm typical high third order intercept: +36 dbm typical low +10 volt supply environmental screening available characteristic typical min/max ta= 25 oc ta = -55 oc to +85 oc frequency 5 - 500 mhz 5 - 500 mhz note: care should always be taken to effectively ground the case of each unit. noise figure (db) 4.6 6.0 max. vswr in <1.4:1 2.0:1 max. out <1.2:1 2.0:1 max. reverse isolation (db) -18 -15 max. power @ 1 db comp. (dbm) +23 +20 min. gain (db) 14.5 13.0 min. specifications typical performance data (absolute) maximum ratings ambient operating temperature ................ -55oc to +100 oc storage temperature ................................. -62oc to +125 oc case temperature .................................................. +125 oc dc voltage ........................................................... +12 volts continuous rf input power .................................. +13 dbm short term rf input power ............. 50 mw (1 minute max.) maximum peak power .................... 0.5 watt (3 sec max.) guaranteed phase noise performance (dbc/hz) frequency typical 100 hz 1 khz 10 khz 100 khz 1 mhz -175 -175 -175 -170 -156 -172 -172 -152 -168 -172 guaranteed * typical intermodulation performance at 25 oc second order harmonic intercept point ....... +56 dbm (typ.) second order two tone intercept point ........ +50 dbm (typ.) third order two tone intercept point ............ +36 dbm (typ.) 2.0 1.5 1.0 2.0 1.5 1.0 3 7 6 5 4 16 14 12 +24 +23 +22 +21 +20 0 - 10 - 20 - 30 start 5 mhz stop 500 mhz start 5 mhz stop 500 mhz start 5 mhz stop 500 mhz start 5 mhz stop 500 mhz start 5 mhz stop 500 mhz start 5 mhz stop 500 mhz 15 13 + 10 10 k 1k 100 k 100 1m -140 -150 -160 -170 -180 -130 _________guarantee __ __ __ __typical -190 * residual phase noise test conditions carrier frequency: 500 mhz power output: +23 dbm temperature: 25 oc agilent es5500 system gain (db) reverse isolation (db) phase noise (dbc/hz) 1 db comp. (dbm) noise figure (db) input vswr output vswr spectrum microwave 2144 franklin drive n.e. palm bay, florida 32905 ph (888) 553-7531 fax (888) 553-7532 spectrum microwave 2707 black lake place philadelphia, pennsylvania 19154 ph (215) 464-4000 fax (215) 464-4001 www.spectrummicrowave.com rev. 3/3/09
|